PARV.KHARE
Home › Engineering Notes › Part 9
Drone & counter-drone engineering · Part 9

Drone Airframe Materials: CFRP, Fibreglass and 3D Printing

Specific strength and stiffness of CFRP, aluminium and steel, the sandwich-panel trick, cheap fibreglass for expendable airframes, and where fibre-reinforced 3D printing is heading.

By Parv Khare · First shared on LinkedIn, August 2026

Specific strength and specific stiffness

Structural material selection for aerospace always starts with two numbers: specific strength (strength/density) and specific stiffness (Young's modulus/density). Carbon-fibre reinforced polymer (CFRP) has a specific tensile strength of roughly 1,000 kN·m/kg and specific stiffness of 70–100 MN·m/kg. Steel: 63 kN·m/kg and 26 MN·m/kg. Aluminium 7075: 195 kN·m/kg and 26 MN·m/kg. CFRP wins on both axes — dramatically.

The foam-core trick

A sandwich panel — CFRP skins over a foam or honeycomb core — achieves even higher structural efficiency by separating the load-carrying skins to increase the section's second moment of area (I) without adding much mass. Bending stiffness scales with I, which grows steeply with skin separation, so moving the skins apart with a light foam core multiplies stiffness for very little added weight. This is why drone wings can be both incredibly light and sufficiently stiff.

Cheap alternatives for expendable airframes

For a vehicle expected to fly once, CFRP is over-engineered. Fibreglass (GFRP) is 4–6× cheaper with about 40–50% of CFRP's specific strength — adequate for 2G load factors at subsonic speeds. Vacuum-infused GFRP over foam is manufacturable with minimal tooling.

The additive manufacturing angle

Fused deposition modelling (FDM) with fibre-reinforced nylons can produce structural airframe parts with specific strength approaching aluminium at a fraction of the tooling cost. For internal structure — ribs, formers, mounting brackets — this is already competitive. For exterior aerodynamic surfaces, surface finish is still a limitation. But it won't be for long.

Part of an ongoing engineering series on drones and counter-drone systems, lightly edited from the original LinkedIn post.

← Part 8: Batteries vs. Fuel: The Energy-Density Maths of Electric DronesPart 11: Why Small Drones Are So Hard for Radar to See →
Written by Parv Khare, Mechanical Engineering student at VIT Vellore, member of Team Rotor FPV and passionate about defence technologies. Follow the series on LinkedIn.