PARV.KHARE
Home › Engineering Notes › Part 19
Drone & counter-drone engineering · Part 19

High-Power Microwave (HPM) Weapons and Drone Swarms

How HPM pulses couple into drone electronics, why a wide beam can engage a whole swarm at once, and why shielding cheap off-the-shelf drones against HPM is so hard.

By Parv Khare · First shared on LinkedIn, November 2026

How HPM works

A high-power microwave (HPM) system generates an intense, short pulse of microwave energy — typically 1–10 GHz — and radiates it through a directional antenna. The pulse enters a target's electronics through apertures (antennas, cable gaps, ventilation holes) and induces voltage spikes in sensitive semiconductor circuits. Above a threshold, those spikes permanently damage transistors and integrated circuits — the electronics are burned out, not just disrupted.

The wide-beam advantage

Unlike a laser that must dwell on a precise spot, an HPM system radiates a beam tens of metres wide at operational ranges, engaging every drone inside it at once. Systems such as Epirus Leonidas are reported to cover an area the size of a football field. Against a tight swarm formation, a single engagement can disable dozens of drones.

Why HPM is hard to shield against cheaply

Proper electromagnetic shielding — a Faraday cage around all electronics — can resist HPM, but it adds mass and cost to every drone. And every aperture (antenna, GPS receiver, camera) is a coupling point; you can't simply "add shielding" without redesigning the whole electronic architecture. Cheap drones built from commercial off-the-shelf electronics are inherently vulnerable, and hardening them pushes their cost toward the point where they lose their economic advantage.

Part of an ongoing engineering series on drones and counter-drone systems, lightly edited from the original LinkedIn post.

← Part 18: How High-Energy Laser Weapons Stop DronesPart 20: Interceptor Drones: Pursuit Guidance, Nets and Cost Arithmetic →
Written by Parv Khare, Mechanical Engineering student at VIT Vellore, member of Team Rotor FPV and passionate about defence technologies. Follow the series on LinkedIn.